Configuration Guide 802.1X Commands
4.48 dot1x valid-ip-acct enable
Use this command to enable IP address-triggered accounting.
Use the no form of this command to restore the default setting.
dot1x valid-ip-acct enable
no dot1x valid-ip-acct enable
This function is disabled by default.
Global configuration mode
Use this command to enable accounting only when users obtain valid IP addresses.
The following example enables IP address-triggered accounting.
Ruijie(config)#dot1x valid-ip-acct enable
4.49 dot1x valid-ip-acct timeout
Use this command to configure IP address-triggered accounting timeout.
Use the no form of this command to restore the default setting.
dot1x valid-ip-acct timeout time
no dot1x valid-ip-acct timeout
IP address-triggered accounting timeout in the unit of minutes
The default is 5 minutes.
Global configuration mode
The SNMP server will not start accounting until users obtain IP addresses. In this case, use this
command to configure the IP address-triggered accounting timeout.
The following example configures IP address-triggered accounting timeout.
To Next Page
Loading...
Need help?
General