Configuration Guide 802.1X Commands
Global configuration mode
Use the show dot1x command to display 802.1X configuration.
The following example sets the request/id packet re-transmission interval to 5 seconds.
Ruijie(config)# dot1x timeout tx-period 5
Displays the information about 802.1X.
4.47 dot1x user-name compatible
Use this command to configure the compatibility function for H3C 802.1X authentication clients and
authentication servers.
Use the no form of this command to restore the default setting.
dot1x user-name compatible
no dot1x user-name compatible
This function is disabled by default.
Global configuration mode
Enable this function when the H3C authentication client and authentication server are used for
802.1X authentication or the H3C authentication server is used for MAB authentication.
The following example configures the compatibility function for H3C 802.1X authentication clients
and authentication servers.
Ruijie(config)# dot1x user-name compatible
To Next Page
Loading...
Need help?
General