Configuration Guide 802.1X Commands
Displays the 802.1X information.
4.45 dot1x timeout supp-timeout
Use this command to set the authentication timeout between the device and the supplicant.
Use the no form of this command to restore the default setting.
dot1x timeout supp-timeout time
no dot1x timeout supp-timeout
Authentication timeout between the device and the supplicant
The range is from 1 to 65,535 seconds.
The default is 3 seconds.
Global configuration mode
Use the show dot1x command to show display 802.1X configuration.
The following example sets the authentication timeout between the device and the supplicant to 10s:
Ruijie(config)# dot1x timeout supp-timeout 10
Displays the information about 802.1x.
4.46 dot1x timeout tx-period
Use this command to set the request/id packet re-transmission interval.
dot1x timeout tx-period time
The request/id packet re-transmission interval, in range from 1 to
65,535 in the unit of seconds
The default is 3 seconds.
To Next Page
Loading...
Need help?
General