Ruijie RG-S29 Series

Command Reference Protocol-independent Configuration Commands
guideline
Examples
The following example sets the precedence of IPv6 packet head as “immediate”:
Ruijie(config-route-map)# set ipv6 precedence immediate
Related
commands
Command
Description
match ipv6 address
Configure the ACL used for matching the packet in IPv6
PBR.
route-map
Use the route map of the policy-based routing.
set default interface
Set the default next-hop egress.
set interface
Set the next hop egress.
set ipv6 default next-hop
Set the default next-hop address for forwarding packets.
set ipv6 next-hop
Set the next-hop address for forwarding packet.
show ipv6 policy
Show the policy-based routing
show route-map
Show the route map configuration.
Platform
description
N/A
6.36 set level
Use this command to set the level of the area where the routes matching the rule are redistributed in
the route map configuration command. Use the no form of this command to remove the setting.
set level { stub-area | backbone }
no set level
Parameter
description
Parameter
Description
stub-area
Redistributes the routes to the OSPF stub
area
backbone
Redistributes the routes to the backbone
area.
Default
configuration
None
Command
mode
Route map configuration mode