Ruijie RG-S29 Series

Command Reference Protocol-independent Configuration Commands
If weight follows any next-hop, the operation mode of this command will be
automatically switched to the WCMP load balancing mode. In the WCMP
load balancing mode, for the nexthop address without configuring the
corresponding weight, the weight is 1 by default.
When the packets select the egress from the policy-based routing and routing table, the priorities are
as bellows.
set ipv6 next-hop;
usual route (the non-default route)
set ipv6 default next-hop
Default route.
Examples
N/A
Related
commands
Command
Description
match ipv6 address
Set the matching rule of policy-based routing.
ipv6 policy route-map
Use the policy-based routing on the interface.
set ipv6 next-hop
Set the next hop of the policy-based routing.
Platform
description
N/A
6.35 set ipv6 precedence
Use this command to set the precedence of the IPv6 head of the packet matching the rule in the route
map configuration mode. Use the no form of this command to remove the configured precedence
setting.
set ipv6 precedence {<0-7> | critical | flash | flash-override | immediate | internet | network | priority |
routine }
no set ipv6 precedence
Parameter
description
Parameter
Description
critical, flash, flash-override, immediate, internet ,
network , priority , routine
The precedence type of the IPv6 head.
0~7
The configurable precedence range.
Default
configuration
N/A
Command
mode
Route map configuration mode
Usage