Ruijie RG-S29 Series

Command Reference RIPng Commands
show ipv6 rip
Displays the RIPng process and statistics.
show ipv6 rip database
Displays the RIPng route.
Platform
Description
N/A
4.7 ipv6 rip enable
Use this command to enable the RIPng on the interface. Use the no form of this command to disable
RIPng on the interface.
ipv6 rip enable
no ipv6 rip enable
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
It is disabled by default.
Command
mode
Interface configuration mode.
Usage Guide
This command is used to add the RIPng interface. Before this command is configured, if the RIPng is
not enabled, use this command to enable the RIPng automatically.
Configuration
Examples
The following example shows how to enable the RIPng on the interface 0/0:
Ruijie(config)# interface ethernet 0/0
Ruijie(config-if)# ipv6 rip enable
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
4.8 ipv6 rip metric-offset
Use this command to set the interface metric value. Use the no form of this command to remove the
metric configurations.
ipv6 rip metric-offset value
no ipv6 rip metric-offset