Ruijie RG-S29 Series User Manual

Configuration Guide IP Source Guard Commands
Ruijie# configure terminal
Ruijie(config)# ip source binding 0000.0000.0001 vlan 1 1.1.1.1 ip-mac
Ruijie(config)# end
The following example adds static user information based on IP binding.
Ruijie# configure terminal
Ruijie(config)# ip source binding 0000.0000.0001 vlan 1 1.1.1.1 ip-only
Ruijie(config)# end
Related
Commands
Command
Description
show ip source binding
Displays the binding information of IP source
address and database.
Platform
Description
N/A
18.2 ip verify source
Use this command to enable IP Source Guard function on the interface.
Use the no form of this command to restore the default setting.
ip verify source [ port-security ]
no ip verify source
Parameter
Description
Parameter
Description
port-security
Configures IP Source Guard to do IP+MAC-based detection.
Defaults
This function is disabled by default.
Command
Mode
Interface configuration mode
Usage Guide
This command enables IP Source Guard function on the interface to do IP-based or IP+MAC-based
detection.
This command is supported on the wired L2 switching port, AP port and sub interface.
IP Source Guard takes effect only on DHCP Snooping untrusted port. In other words, IP Source
Guard does not take effect when configuring it on Trust port or the port which is not controlled by
DHCP Snooping.
Configuration
Examples
The following example enables IP-based IP Source Guard function.
Ruijie# configure terminal
Ruijie(config)# interface GigabitEthernet 0/1

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English