Ruijie RG-S29 Series

Command Reference OSPFv2 Commands
Platform
Description
N/A
2.53 show ip ospf interface
Use this command to display the OSPF-associated interface information.
show ip ospf [ process-id ] interface [ interface-type interface-number | brief ]
Parameter
Description
Parameter
Description
process-id
OSPF process ID
interface-type
(Optional) type of the specified interface
interface-number
(Optional) number of the specified interface
brief
Displays the summary of the interface.
Defaults
N/A
Command
Mode
Privileged EXEC mode
Usage Guide
This command displays the OSPF information on the interface.
Configuration
Examples
The following example displays the output of the show ip ospf interface fastEthernet 0/1 command:
Ruijie# show ip ospf interface fastEthernet0/1
FastEthernet 0/1 is up, line protocol is up
Internet Address 192.88.88.27/24, Ifindex 4, Area 0.0.0.0, MTU 1500
Matching network config: 192.88.88.0/24
Process ID 1, Router ID 1.1.1.1, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1,BFD enabled
Designated Router (ID) 1.1.1.1, Interface Address 192.88.88.27
Backup Designated Router (ID) 3.3.3.3, Interface Address 192.88.88.72
Timer intervals configured,Hello 10,Dead 40,Wait 40,Retransmit 5
Hello due in 00:00:03
Neighbor Count is 1, Adjacent neighbor count is 1
Crypt Sequence Number is 70784
Hello received 1786 sent 1787, DD received 13 sent 8
LS-Req received 2 sent 2, LS-Upd received 29 sent 53
LS-Ack received 46 sent 23, Discarded 1
The following table describes the fields in the output of the show ip ospf interface serial1/0
command.
Field
Description