Command Reference OSPFv2 Commands
TOS value, which can be 0 only now.
Displays the metric of the route corresponding to the LSA.
IP address through which traffic is forwarded to the destination
network. If this address is 0.0.0.0, the data traffic will be forwarded to
the device that generates the link state.
External route tag. Each external route has a 32-byte route tag. The
OSPF does not use the route tag by itself, but it will be used in
redistributing OSPF routes by other routing process.
The following example displays the output of the show ip ospf database database-summary
command:
Ruijie# show ip ospf database database-summary
OSPF process 1:
Device Link States : 4
Network Link States : 2
Summary Link States : 4
ASBR-Summary Link States : 0
AS External Link States : 4
NSSA-external Link States: 2
The following table describes the fields in the output of the command show ip ospf database
database-summary.
Number of device LSAs in the area
Number of network LSAs in the area
Number of summary LSAs in the area
Number of ASBR summary LSAs in the area
Number of NSSA LSAs in the area
Number of NSSA LSAs in the area
To Next Page
Loading...
Need help?
General