Command Reference OSPFv3 Commands
valid id range from 0 to 255.
Point-to-point network type: PPP, SLIP, frame relay point-to-point sub-interface and X.25
point-to-point sub-interface encapsulation.
NBMA network type: frame relay(except for the point-to-point sub-interface) and X.25 encapsulation
(except for the point-to-point sub-interface)
Broadcast network type: Ethernet encapsulation.
The point-to-multipoint network type is not the default type.
Interface configuration mode.
You can set the network type of the interface according to the actual link type applied and the
topology.
The following example sets the network type of the interface that participates in the OSPFv3 to
point-to-point.
Ruijie(config)# interface ethernet 1/0
Ruijie(config-if)# ipv6 ospf network point-to-point
Sets the interface priority.
Displays the OSPFv3 interface information.
Sets the interface to participate in the OSPFv3
routing process.
Use this command to set the interface priority. Use the no form of this command to restore the default
setting.
ipv6 ospf priority number-value [ instance instance-id ]
no ipv6 ospf priority [ instance instance-id ]
The priority of the interface.
Its range is from 0 to 255.
Configures the specific OSPFv3 instance on the interface. Its range is
from 0 to 255.
To Next Page
Loading...
Need help?
General