Command Reference OSPFv3 Commands
The default priority is 1.
Interface configuration mode.
In the broadcast network type, it is necessary to elect the DR/BDR. In electing the DR/BDR, the
device of a higher priority is preferred. If several devices are of the same priority, the one with the
largest router-ID is preferred.
The device with the priority level of 0 does not participate in the election of DR/BDR.
The following example disables the interface from being elected as the DR/BDR.
Ruijie(config)# interface ethernet 1/0
Ruijie(config-if)# ipv6 ospf priority 0
Sets the network type of an interface.
Displays the OSPFv3 interface information.
Configures the specific OSPFv3 instance on
the interface.
3.28 ipv6 ospf retransmit-interval
Use this command to set the interval for the interface to retransmit the LSA. Use the no form of this
command to restore the default setting.
ipv6 ospf retransmit-interval seconds [ instance instance-id ]
no ipv6 ospf retransmit-interval [ instance instance-id ]
Interval for retransmitting the LSA.
Its range is from 1 to 65535 in the unit of seconds.
Configures the specific OSPFv3 instance on the interface.
The default is five seconds.
Interface configuration mode.
To ensure the reliability of the routing information transmission, the LSA sent to the neighbor shall be
To Next Page
Loading...
Need help?
General