Command Reference Interface Commands
Use this command to achieve EEE on the interface in Low Power Idle(LPI) mode,
The following example enables EEE on GigabitEthernet 0/1.
Ruijie(config)#interface GigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# eee enable
Use this command to recover the interface in violation.
errdisable recovery [ interval time ]
Time for the command to take effect. The range is from 30 to 86,400
seconds.
By default, it is disabled.
Global configuration mode.
Use the command to recover the port that triggers violation after being configured with the violation
shutdown command.
The following example recovers the violation interface gigabitethernet 1/1.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# errdisable recovery
switchport port-security violation shutdown
Configures the port security violation to
shutdown.
To Next Page
Loading...
Need help?
General