Command Reference Interface Commands
1.9 fiber antifake enable
Use this command to enable or disable the optical module antifake detection. Use the no form of this
command to restore the default setting.
fiber antifake {ignore | enable}
By default, optical module antifake detection is disabled.
Global configuration mode
If the optical module antifake detection is enabled by default, when a non-original optical module is
inserted, alarm logs are printed.
The following example enables the optical module antifake detection.
Ruijie(config)# fiber antifake enable
Use this command to enable or disable the flow control. Use the no form of this command to restore
the default setting.
flowcontrol { auto | off | on}
Self-negotiates the flow control.
Disables the flow control.
To Next Page
Loading...
