Ruijie RG-S29 Series

Command Reference VRRP Commands
Ruijie(config-if-GigabitEthernet 0/0)#ipv6 enable
Ruijie(config-if-GigabitEthernet 0/0)#ipv6 address 2001::2/64
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ipv6 FE80::1
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ipv6 2001::1
Ruijie(config-if-GigabitEthernet 0/0)#vrrp ipv6 1 timers advertise 4
The following example sets the IPv4 VRRP advertisement interval as 50 centi-seconds.
Ruijie#configure terminal
Ruijie(config)#interface GigabitEthernet 0/0
Ruijie(config-if-GigabitEthernet 0/0)#no switchport //used on the switch.
Ruijie(config-if-GigabitEthernet 0/0)#ip address 10.0.1.1 255.255.255.0
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ip 10.0.1.20
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 timers advertise csec 50
The following example sets the IPv6 VRRP advertisement interval as 50 centi-seconds.
Ruijie#configure terminal
Ruijie(config)#interface GigabitEthernet 0/0
Ruijie(config-if-GigabitEthernet 0/0)#no switchport //used on the switch.
Ruijie(config-if-GigabitEthernet 0/0)#ipv6 enable
Ruijie(config-if-GigabitEthernet 0/0)#ipv6 address 2001::2/64
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ipv6 FE80::1
Ruijie(config-if-GigabitEthernet 0/0)#vrrp 1 ipv6 2001::1
Ruijie(config-if-GigabitEthernet 0/0)#vrrp ipv6 1 timers advertise csec 50
Related
Commands
Command
Description
vrrp group ip ipaddress [ secondary ]
Enables the VRRP function and set the IP
address for the virtual device.
vrrp group timers learn
Enables the timer learning function.
Platform
Description
N/A
4.13 vrrp timers learn
Use this command to enable the timer learning function.
Use the no form of this command to restore the default setting.
vrrp [ ipv6 ] group timers learn
no vrrp [ ipv6 ] group timers learn
Parameter
Description
Parameter
Description
ipv6
Applies to IPv6 VRRP.
group
VRRP group number
Defaults
This function is disabled by default. Even if the VRRP function is enabled, the timer learning function
is disabled by default.