Command Reference IGMP Snooping Commands
2.19 ip igmp snooping querier timer expiry
Use this command to specify the expiration timer for non-querier.
Use no form of this command to restore the default setting.
ip igmp snooping [ vlan vid ] querier timer expiry seconds
ip igmp snooping [ vlan vid ] querier timer expiry seconds
default ip igmp snooping [ vlan vid ] querier timer expiry
Theexpiration timer from 60 to 300 in the unit of seconds
VLAN ID. By default, the specified version is supported on all VLANs.
The default is 125 seconds.
Global configuration mode
After globally enabling IGMP querier, if the device is elected as a non-querier, execute this command to
change the expiration timer for non-querier.
If expiration timer has been configured in the corresponding VLAN, the value specified in VLAN will be
used first.
The following example configures the non-querier expiration timer on the device.
Ruijie(config)# ip igmp snooping querier timer expiry 60
The following example configures the non-querier expiration timer in VLAN 3.
Ruijie(config)# ip igmp snooping vlan 3 querier timer expiry 60
2.20 ip igmp snooping querier version
Use the following commands to specify IGMP Snooping querier version.
ip igmp snooping [ vlan vid ] querier version 1
ip igmp snooping [ vlan vid ] querier version 2
Use no or default form of this command to restore to the default setting.
no ip igmp snooping [ vlan vid ] querier version
default ip igmp snooping [ vlan vid ] querier version
To Next Page
Loading...
