Command Reference DHCPv6 Commands
Use this command to enable the DHCPv6 client and request for the prefix address information.
Use the no form of this command to restore the default setting.
ipv6 dhcp client pd prefix-name [ rapid-commit ]
Defines the IPv6 prefix name.
Allows the two-message interaction process.
This function is disabled by default.
Interface configuration mode
With the DHCPv6 client mode disabled, use this command to enable the DHCPv6 client mode on the
interface.
With the ipv6 dhcp client pd command enabled, the DHCPv6 client sends the prefix request to the
DHCPv6 server
The keyword rapid-commit allows the client and the server two-message interaction process. With
this keyword configured, the solicit message sent by the client includes the rapid-commit item.
The following example enables the prefix information request on the interface.
Ruijie(config)# interface fastethernet 0/1
Ruijie(config-if)# ipv6 dhcp client pd pd_name
Resets the DHCPv6 client function on the
interface.
Displays the DHCPv6 interface configuration.
5.5 ipv6 dhcp relay destination
Use this command to enable the DHCPv6 relay service and configure the destination address to
which the messages are forwarded.
Use the no form of this command to restore the default setting.
ipv6 dhcp relay destinationipv6-address [ interface-type interface-number ]
To Next Page
Loading...
Need help?
General