Command Reference DHCPv6 Commands
The following example clears the packet sending and receiving condition with the DHCPv6 Relay
function enabled.
Ruijie# clear ipv6 dhcp relay statistics
show ipv6 dhcp relay statistics
Displays the statistical information.
Use this command to enable DHCPv6 client mode and request the IANA address from the DHCPv6
server. Use the no form of this command to restore the default setting.
ipv6 dhcp client ia [rapid-commit]
Allows the two-message interaction process.
This function is disabled by default.
Interface configuration mode
This command is used to enable DHCPv6 client mode and request the IANA address from the
DHCPv6 server,
The rapid-commitkey allows the two-message interaction process between the client and the server.
After the key is configured, the solicit message transmitted by the client contains the rapid-commit
option.
The following example enables the request for the IANA address on the interface.
Ruijie(config)# interface fastethernet 0/1
Ruijie(config-if)# ipv6 dhcp client ia
To Next Page
Loading...
Need help?
General