Ruijie RG-S29 Series

Command Reference VSU Commands
show switch virtual
Display the domain ID as well as the ID and role of each chassis.
Platform
Description
N/A
7.17 switch crc
Use this command to configure parameters for frame error detection.
Use the no form of this command to restore the default setting.
switch crc errors error_num times time_num
no switch crc
Parameter
Description
Parameter
Description
error_num
Limits the number of error frames increasing from that in the last
detection. If the increased number is greater than error_num, it is taken
as an error.
time_num
When the error count exceeds the time_num, the device will take
actions (prompting a message or disabling the port).
Defaults
The default error_num is 3.
The default time_num is 10.
Command Mode
config-vs-domain configuration mode
Usage Guide
N/A
Configuration
Examples
The following example sets the error_time and time_num parameters to 10 and 5 respectively.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)#
Ruijie(config-vs-domain)#switch crc errors 10 times 5
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
7.18 switch description
Use this command to configure the description for a VSU switch.
Use the no form of this command to remove the setting.
switch switch_id description dev-name
no switch switch_id description