Command Reference VSU Commands
Device description, no greater than 32 characters.
config-vs-domain configuration mode
This command is configured on a device in whether standalone or VSU mode and takes effect
immediately after configuration,
The following example configures the description for a VSU switch.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# switch 1 description buildingA
Ruijie(config-vs-domain)# exit
Use this command to modify the domain ID of a device in VSU mode.
Use the no form of this command to restore the default setting.
switch switch_id domain new_domain_id
no switch switch_id domain
ID of the running device in VSU mode.
The range depends on products. For details, see the
Configuration Guide
.
New domain ID, in the range from 1 to 255.
The default new_domain_id is 100 by default.
config-vs-domain configuration mode
Use this command only in VSU mode. In addition, the setting can take effect only after the device
is restarted.