Ruijie RG-S29 Series

Command Reference RIPng Commands
Parameter
Description
Parameter
Description
value
Sets the interface metric value on the interface. The valid range is
from 1 to 16.
Defaults
The default value is 1.
Command
mode
Interface configuration mode.
Usage Guide
Before the route is added to the routing list, the interface metric value shall be upon the route metric.
To this end, the interface metric value influences the route usage.
Configuration
Examples
The following example shows how to set the metric value of the interface Ethernet 0/1 as 5:
Ruijie(config)# interface ethernet 0/1
Ruijie(config-if)# ipv6 rip metric-offset 5
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
4.9 ipv6 router rip
Use this command to create the RIPng process and enter routing process configuration mode. Use
the no form of this command to remove the RIPng process.
ipv6 router rip
no ipv6 router rip
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
No RIPng process is configured by default.
Command
mode
Global configuration mode.
Usage Guide
N/A.