Configuration Guide 802.1X Commands
Use this command to restore 802.1X configuration to the default setting.
Global configuration mode
This command is used to restore 802.1X configuration for quick re-configuration.
The following example restores 802.1X configuration to the default setting.
Ruijie(config)# dot1x default
Displays the 802.1X information.
4.23 dot1x default-user-limit
Use this command to set the maximum auth-user number on controlled interfaces.
Use the no form of this command to restore the default setting.
dot1x default-user-limit num
no dot1x default-user-limit
The maximum auth-user number allowed by a controlled
interface, in the range from 1 to 1,000,000
To Next Page
Loading...
Need help?
General