Ruijie RG-S29 Series User Manual

Configuration Guide 802.1X Commands
Defaults
By default, no limit is set for the auth-user number.
Command
mode
Interface configuration mode
Usage Guide
This command is used to limit the number of users to be authenticated on a specific port.
Configuration
Examples
The following example sets the maximum auth-user number on a controlled interface.
Ruijie(config-if)# dot1x default-user-limit 10
Related
Commands
Command
Description
show dot1x port-control
interface fastEthernet 0/10
Displays the number of users allowed by a specific 802.1X
interface.
show dot1x port-control
interface fastEthernet 0/10
Displays the number of users allowed by a specific 802.1X
interface.
Platform
Description
N/A
4.24 dot1x dynamic-vlan enable
Use this command to enable dynamic VLAN.
Use the no form of this command to disable the function.
dot1x dynamic-vlan enable
no dot1x dynamic-vlan enable
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
Dynamic VLAN is disabled by default.
Command
Mode
Interface configuration mode
Usage Guide
This command is used to assign VLANs to authenticated users dynamically.
Configuration
Examples
The following example enables dynamic VLAN.
Ruijie(config-if)# dot1x dynamic-vlan enable
Related
Commands
Command
Description
show dot1x
Displays the information about 802.1X.

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English