Configuration Guide 802.1X Commands
Use this command to configure the guest VLAN for port-control.
Use the no form of the command to disable the function.
The guest VLAN is not configured by default.
Interface configuration mode
Before using guest VLAN, you need to execute dot1x dynamic-vlan enable command first, or the
configured guest VLAN does not take effect.
When configuring guest VLAN, it is recommended not to modify L2 attribute of the port, especially not
to add the port to a VLAN manually.
The following example configures VLAN 20 as 802.1X guest VLAN.
Ruijie(config-if)# dot1x guest-vlan 20
Displays the 802.1X configuration.
4.26 dot1x mac-auth-bypass
Use this command to configure single MAB authentication.
Use the no form of this command to restore the default setting.
This function is disabled by default.
To Next Page
Loading...
Need help?
General