Configuration Guide 802.1X Commands
Interface configuration mode
Use this command on a single dumb terminal.
The following example configures single MAB authentication.
Ruijie(config-if-GigabitEthernet 0/0)# dot1x mac-auth-bypass
show dot1x port-control interface
Displays the information about 802.1X on the interface.
4.27 dot1x mac-auth-bypass multi-user
Use this command to configure multiple MAB authentications.
Use the no form of this command to restore the default setting.
dot1x mac-auth-bypass multi-user
no dot1x mac-auth-bypass multi-user
This function is disabled by default.
Interface configuration mode
Use this command when the interface is connected with multiple dumb terminals.
The following example configures multiple MAB authentications.
Ruijie(config-if-GigabitEthernet 0/0)# dot1x mac-auth-bypass multi-user
To Next Page
Loading...
Need help?
General