Configuration Guide 802.1X Commands
4.28 dot1x mac-auth-bypass timeout-activity
Use this command to set the MAB authentication timeout interval.
dot1x mac-auth-bypass timeout-activity time
no dot1x mac-auth-bypass timeout-activity
The online time, in the range from 1 to 65,535 in the unit
of seconds
Interface configuration mode
Use this command to set the MAB authentication timeout interval for dumb terminals.
The following example sets the MAB authentication timeout interval.
Ruijie(config-if-GigabitEthernet 0/0)# dot1x mac-auth-bypass
timeout-activity 3600
show dot1x port-control interface
Displays the 802.1X information.
show dot1x port-control interface
Displays the 802.1X information.
4.29 dot1x mac-auth-bypass violation
Use this command to configure the MAB violation.
Use the no form of this command to restore the default setting.
dot1x mac-auth-bypass violation
no dot1x mac-auth-bypass violation
This function is disabled by default.
Interface configuration mode
To Next Page
Loading...
Need help?
General