Configuration Guide 802.1X Commands
This command is used to configure the MAB violation on the port with only one dumb terminal in
single MAB environment.
The following example configures the MAB violation.
Ruijie(config-if-GigabitEthernet 0/0)# dot1x mac-auth-bypass violation
show dot1x port-control interface
Displays the 802.1X information.
4.30 dot1x mac-auth-bypass vlan
Use this command to configure the MAB VLAN function.
Use the no form of this command to restore the default setting.
dot1x mac-auth-bypass vlan vlan-list
no dot1x mac-auth-bypass vlan vlan-list
Configures the MAB VLANs.
This function is disabled by default.
Interface configuration mode
Use this command to allow users within specified VLANs on the port to perform MAB authentication.
The following example configures MAB VLANs.
Ruijie(config-if-GigabitEthernet 0/0)# dot1x mac-auth-bypass vlan 5，8-20
To Next Page
Loading...
Need help?
General