Configuration Guide 802.1X Commands
4.31 dot1x max-req
Use this command to set the maximum attempts of authentication requests.
Global configuration mode
Use the show dot1x command to display the 802.1X configuration.
The following example sets the maximum attempts of authentication requests to 2.
Ruijie(config)# dot1x max-req 2
Displays the information about 802.1X.
4.32 dot1x multi-account enable
Use this command to enable the user with one single MAC address to perform authentication with
multiple accounts.
Use the no form of this command to restore the default setting.
dot1x multi-account enable
no dot1x multi-account enable
This function is disabled by default.
Global configuration mode
Use the command to enable the multiple-account authentication if you want to switch the username in
the authentication or re-authentication, especially in the windows domain authentication.
To Next Page
Loading...
Need help?
General