Configuration Guide 802.1X Commands
The following example enables the multiple-account authentication.
Ruijie(config)# dot1x multi-account enable
4.33 dot1x multi-mab quiet-period
Use this command to set the quiet time after the multiple MAB authentication failure.
dot1x multi-mab quiet-period time
Sets the quiet period after the multiple MAB authentication failure, in
the range from 0 to 65,535 in the unit of seconds.
The default is 0 second, indicating no quiet period.
Global configuration mode
The default setting is recommended.
The following example sets the quiet period after the multiple MAB authentication failure to 2
seconds.
Ruijie(config)# dot1x multi-mab quiet-period 2
4.34 dot1x port-control auto
Use this command to configure the 802.1X authentication on the port.
Use the no form of this command to restore the default setting.
To Next Page
Loading...
