Command Reference Line Commands
No parity check is configured by default.
Parity is required in communication through some devices (such as async serial ports and console
ports).
The following example configures even parity for the current terminal.
Ruijie#terminal parity even
Use this command to configure the baud rate for the current terminal. Use the no form of this
command to restore the default setting,
Sets the baud rate, in the range from 9600 to 115200.
The following example sets the baud rate for the current terminal to 115200,
Ruijie# terminal speed 115200
To Next Page
Loading...
Need help?
General