Command Reference SNMP Commands
1 SNMP Commands
1.1 no snmp-server
Use this command to disable the SNMP agent function.
SNMP agent is enabled by default.
Global configuration mode.
This command disables the SNMP agent services of all versions supported on the device.
The following example disables the SNMP agent.
Ruijie(config)# no snmp-server
Use this command to display the SNMP configuration.
show snmp [ mib | user | view | group | host | locked-ip | process-mib-time ]
Displays the SNMP MIBs supported.
Displays the SNMP user information.
Displays the SNMP view information.
Displays the SNMP user group information.
Displays the explicit host configuration.
Displays the source IP addresses locked after continuous SNMP
To Next Page
Loading...
Need help?
General