Configuration Guide AAA Commands
1.4 aaa accounting update
Use this command to enable the accounting update function.
Use the no form of this command to restore the default setting.
This function is disabled by default.
Global configuration mode
If the AAA security service is not enabled, the accounting update function cannot be used. This
command is used to set the accounting interval if the AAA security service has been enabled.
The following example enables the accounting update function.
Ruijie(config)# aaa new-model
Ruijie(config)# aaa accounting update
Enables the AAA security service.
Defines a network accounting method list.
1.5 aaa accounting update periodic
Use this command to set the interval of sending the accounting update message.
Use the no form of this command to restore the default setting.
aaa accounting update periodic interval
no aaa accounting update periodic
Interval of sending the accounting update message, in the unit of
minutes. The shortest interval is 1 minute.
The default is 5 minutes.
Global configuration mode
To Next Page
Loading...
Need help?
General