Configuration Guide 802.1X Commands
This function is disabled by default.
Interface configuration mode
With this function enabled, if no user authentication is performed on the ports initially, after all
RADIUS servers are invalidated, the user will initiate the authentication and the port will enter the IAB
status and to be added to the VLAN configured. If this function is disabled, the VLAN of the port is not
changed when the port is in the IAB status.
Ruijie(config-if-GigabitEthernet 0/5)#dot1x critical vlan 10
Use this command to enable debug information print for a user with a specified MAC address.
Use the no form of this command to clear the debug information.
no dot1x dbg-filter H.H.H
The MAC address of a user
Debug information of all authentication users is printed by default.
Global configuration mode
Use this command to print the debug information of a specific user If you want to locate the fault on
the network where there are multiple users.
The following example prints the debug information of the device with the specified MAC address.
Ruijie(config)# dot1x dbg-filter 00d0.f800.0001
To Next Page
Loading...
Need help?
General