Command Reference Interface Commands
1.6 duplex
Use this command to specify the duplex mode for the interface. Use the no form of this command to
restore the default setting.
duplex { auto | full | half }
Self-adaptive full duplex and half duplex
Interface configuration mode.
The duplex mode is associated with the interface type. Use show interfaces to display the duplex
mode of the interface
The following example specifies the duplex mode for the interface.
Ruijie(config-if)# duplex full
Displays the interface information.
Use this command to enable Energy Efficient Ethernet (EEE) on the interface.
This function is disabled by default.
Interface configuration mode
To Next Page
Loading...
Need help?
General