Command Reference Interface Commands
This command is only used on the switch port, member port of the L2 Aggregate port, routing port,
and member port of the L3 aggregate port. This command is equal to the shutdown and no
shutdown commands.
The following example resets the interface gigabitethernet 1/1.
Ruijie# clear interface gigabitethernet 1/1
Use this command to configure the alias of interface. Use the no form of this command to restore the
default setting.
No alias is configured by default.
Interface configuration mode.
Use show interfaces to display the interface information, including the alias.
The following example configures the alias of interface.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if)# description GBIC-1
Displays the interface information.
To Next Page
Loading...
