Command Reference MSTP Commands
The following example enables tc-guard to prevent TC packets from being flooded.
Ruijie(config)# spanning-tree tc-protection tc-guard
9.43 spanning-tree tx-hold-count
Use this command to configure the TxHoldCount of the STP, the maximum number of the BPDU
messages sent in one second. Use the no form of this command to restore the default setting.
spanning-tree tx-hold-count tx-hold-count
no spanning-tree tx-hold-count
Indicates the maximum number of BPDUs sent per second. The
value ranges from 1 to 10. The default value is 3.
Global configuration mode.
The following example sets the maximum number of the BPDU messages sent in one second.
Ruijie(config)# spanning-tree tx-hold-count 5
Displays the global MSTP configuration.
To Next Page
Loading...
Need help?
General