Ruijie RG-S29 Series User Manual

Command Reference Basic Configuration Management Commands
message
Contents of the message.
Defaults
N/A
Command
Mode
Global configuration mode
Usage Guide
This command is used to configure the welcome message. The system discards all the characters
next to the terminating symbol.
When you are logging in to the device, the MOTD message is displayed at first, and then the banner
login message. After you have logged in, the EXEC message or the incoming message is displayed.
If it’s a reverse Telnet session, the incoming message is displayed. Otherwise, the EXEC message is
displayed.
The messages are for all lines. If you want to disable display the EXEC message on a specific line,
configure the no exec-banner command on the line.
Configuration
Examples
The following example configures a welcome message.
Ruijie(config)# banner exec $ Welcome $
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
2.3 banner incoming
Use this command to configure a prompt message for reverse Telnet session. Use the no form of this
command to remove the setting.
banner incoming c message c
no banner incoming
Parameter
Description
Parameter
Description
c
Separator of the message. Delimiters are not allowed in the
message.
message
Contents of the message.
Defaults
N/A
Command
Mode
Global configuration mode

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English