Ruijie RG-S29 Series

Configuration Guide 802.1X Commands
dot1x auth-fail max-attempt value
no dot1x auth-fail max-attempt
Parameter
Description
Parameter
Description
value
The maximum auth-attempts
Defaults
The default is 3.
Command
Mode
Global configuration mode
Usage Guide
Use the show dot1x command to adjust the maximum authentication attempts for those failed users.
Configuration
Examples
The following example sets the maximum auth-attempts to 2.
Ruijie(config)# dot1x auth-fail max-attempt 2
Related
Commands
Command
Description
show dot1x
Displays the 802.1x configuration.
Platform
Description
N/A
4.10 dot1x auth-fail vlan
Use this command to enable the auth-fail VLAN.
Use the no form of this command to restore the default setting.
dot1x auth-fail vlan vlan-id
no dot1x auth-fail vlan
Parameter
Description
Parameter
Description
vlan-id
Auth-fail VLAN ID
Defaults
No auth-fail VLAN is enabled by default.
Command
Mode
Interface configuration mode
Usage Guide
Use this command to allow auth-fail users to access network by joining in a VLAN.
Configuration
Examples
The following example enables the auth-fail VLAN.
Ruijie(config-if)# dot1x auth-fail vlan 30