Ruijie RG-S29 Series

Command Reference Line Commands
terminal no stopbits
Parameter
Description
Parameter
Description
1
Configures 1 stopbit,
2
Configures 2 stopbits.
Defaults
The default is 2.
Command
Mode
Privileged EXEC mode
Usage Guide
N/A
Configuration
Examples
The following example configures 1 stopbit for the current terminal.
Ruijie#terminal stopbits 1
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
3.44 terminal stop-character
Use this command to configure the stop character for software flow control on the current terminal.
Use the no form of this command to restore the default setting.
terminal stop-character ascii-value
terminal no stop-character
Parameter
Description
Parameter
Description
ascii-value
Sets the ASCII value corresponding to the stop character for software
flow control on the current terminal, in the range from 0 to 255.
Defaults
The default is Ctrl+S (ASCII: 19).
Command
Mode
Privileged EXEC mode
Usage Guide
N/A
Configuration
The following example configures Ctrl+Z (ASCII: 26) for stopping software flow control on the current