Configuration Guide Web Authentication Commands
Template configuration mode
The method-list parameter in this command should be consistent with the Web authentication method
list configured in AAA.
The first generation authentication does not support the authentication method list configuration.
The following example sets the mlist1 authentication method for the eportalv2 template.
Ruijie(config.tmplt.eportalv2)#authentication mlist1
Use this command to set a binding mode for the template.
Use the no form of this command to restore the default setting.
bindmode { ip-mac-mode | ip-only-mode }
IP+MAC mode. The device will write both the IP address information
and the MAC address information into the forwarding entry.
IP only mode. The device writes only the IP address information into
the forwarding entry. On the L3 network, it is recommended to adopt
this mode in case that the MAC address is inaccurate.
The default is ip-mac-mode.
Template configuration mode
The following example adopts the IP only mode for the eportalv2 template.
Ruijie(config.tmplt.eportalv2)# bindmode ip-only-mode
To Next Page
Loading...
Need help?
General