Ruijie RG-S29 Series User Manual

Configuration Guide Web Authentication Commands
Defaults
DHCP IP address check is disabled by default.
Command
Mode
Global configuration mode
Usage Guide
Only users whose IP addresses are allocated by DHCP are allowed to take authentication.
Configuration
Examples
The following example enables DHCP IP address check.
Ruijie (config)# web-auth dhcp-check
Platform
Description
N/A
5.30 web-auth direct-host
Use this command to set the authentication-exempted IP/MAC address range.
Use the no form of this command to restore the default setting.
web-auth direct-host { ip-address [ ip-mask ] [ arp ] | mac-address } [ port interface-name ]
no web-auth direct-host { ip-address [ ip-mask ] | mac-address }
Parameter
Description
Parameter
Description
ip-address
IPv4 address of authentication-exempted user
ip-mask
Mask of the IPv4 address free of authentication (optional).
port interface-name
Binds user’s IP address with a port of the access device (optional).
arp
If ARP CHECK is enabled on the access device, keyword arp is
needed for ARP binding of the IP address used by users free of
authentication (optional). It is necessary for IPv4 addresses only.
mac-address
MAC address of authentication-exempted user
Defaults
No user is exempted from authentication. All users must pass the Web authentication to access the
restricted network resources.
Command
Mode
Global configuration mode
Usage Guide
When a user is set to be exempted from authentication, it can access all reachable network resources
without Web authentication.
Up to 50 users can be set to be exempted from authentication.
Configuration
Examples
The following example sets the user with the IP address 172.16.0.1 to be exempted from
authentication.
Ruijie(config)# web-auth direct-host 172.16.0.1
The following example sets the user with the MAC address 0000:5e00:0101 to be exempted from

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English