Configuration Guide GSN Commands
12 GSN Commands
12.1 security address-bind enable
Use this command to enable GSN address binding on an interface.
Use the no form of this command to disable this function.
security address-bind enable
no security address-bind enable
GSN address binding is disabled.
Interface configuration mode
This command takes effect only when the global security network (GSN) function is enabled and the
interface is authenticated.
802.1x IP authorization should be disabled when the GSN address binding policy is applied.
The following example enables GSN address binding on GigabitEthernet 0/3.
Ruijie# configure terminal
Ruijie(config)# interface gigabitEthernet 0/3
Ruijie(config-if-GigabitEthernet 0/3)# security address-bind enable
Ruijie(config)# exit
Use this command to configure the security community to communicate with the SMP server.
Use the no form of this command to remove the security community setting.
security { [ v1 | v2 ] community community | v3 user username }
no security { [ v1 | v2 ] community community | v3 user username }
To Next Page
Loading...
Need help?
General