Configuration Guide GSN Commands
Take care to set the sending interval of security events properly. Too small value may cause the drop
of security event messages, and too large value may cause that the security event messages cannot
be received in a long period.
The following example configures the sending interval for security events to 10.
Ruijie# security event interval 10
The following example restores the sending interval for security events to the default setting.
Ruijie(config)# no security event interval
show security event interval
Displays the interval of security event.
Use this command to enable GSN.
Use the no form of this command to disable GSN.
GSN is disabled by default.
Global configuration mode
Use this command to enable GSN on the device.
The following example enables GSN.
Ruijie(config)# security gsn enable
The following example disables GSN.
Ruijie(config)# security gsn enable
To Next Page
Loading...
Need help?
General