Configuration Guide CPU Protection Commands
The following example sets the BPDU bandwidth to 200 pps.
Ruijie# configure terminal
Ruijie(config)# cpu-protect type bpdu bandwitdth 200
Ruijie(config)#show cpu-protect type bpdu
Packet Type Traffic-class Bandwidth(pps) Rate(pps) Drop(pps)
Total Total Drop
------------------ ------------- -------------- --------- ---------
-------- ----------
bpdu 6 200 0 0 0 0
13.6 cpu-protect type traffic-class
Use this command to set the priority queue (PQ) of the packet.
Use the no form of this command to restore the default setting.
cpu-protect type packet-type traffic-class traffic-class-num
no cpu-protect type packet-type traffic-class
Packet type, which varies with products
An integer number varying with products. Indicates the bandwidth
value of the CPU port.
The default PQ varies with products.
Global configuration mode
The following example sets the PQ of BPDU packets to 5.
Ruijie# configure terminal
Ruijie(config)# cpu-protect type bpdu traffic-class 5
Ruijie(config)#show cpu-protect type bpdu
Packet Type Traffic-class Bandwidth(pps) Rate(pps) Drop(pps)
Total Total Drop
To Next Page
Loading...
Need help?
General