Ruijie RG-S29 Series

Configuration Guide ARP-Check Commands
16 ARP-Check Commands
16.1 arp-check
Use this command to enable the ARP check function on the Layer 2 interface.
Use the no form of this command to restore the default setting.
arp-check
no arp-check
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is disabled by default.
Command
mode
Interface configuration mode
Usage Guide
The ARP check function generates the ARP filtering information according to legal user information,
implementing the illegal ARP packet filtering on the network.
Configuration
Examples
This following example enables the APR check function on interface GigabitEthernet 0/1.
Ruijie# configure terminal
Ruijie(config)# interface GigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# arp-check
Ruijie(config-if-GigabitEthernet 0/1)# end
Related
Commands
Command
Description
show interfaces arp-check list
Displays the ARP check entries.
Platform
Description
N/A
16.2 show interface arp-check list
Use this command to display the ARP check entries on the Layer 2 interface.
show { interface [ interface-type interface-number ] } arp-check list
Parameter
Parameter
Description