Configuration Guide Anti-ARP Spoofing Commands
20 Anti-ARP Spoofing Commands
20.1 anti-arp-spoofing ip
Use this command to enable anti-ARP spoofing.
Use the no form of this command to disable this function.
anti-arp-spoofing ip ip-address
no anti-arp-spoofing ip ip-address
The anti-ARP spoofing function is disabled by default.
Interface configuration mode
This command is used to enable anti-ARP spoofing on only L2 interfaces.
Use the show anti-arp-spoofing command to display the configuration.
The following example enables anti-ARP spoofing.
Ruijie(config)#interface fastEthernet 0/1
Ruijie(config-if)#anti-arp-spoofing ip 192.168.1.1
Displays the anti-ARP spoofing configuration.
20.2 show anti-arp-spoofing
Use this command to display the anti-ARP spoofing configuration on all interfaces.
To Next Page
Loading...
