Command Reference SYS Commands
You can use this command to enable the detection of the memory low watermark and set the memory
watermark threshold. When the system memory is less than this threshold, the system will print prompts.
The following example sets the low watermark threshold of the memory to 500,000 KB and enables
detection.
Ruijie(config)#memory low-watermark 500000
Use this command to reload the device.
reload [ at { hour [ :minute [ :second ] ] } [ month [ day [ year ] ] ]
hour [ :minute [ :second ] ]
Sets the restart time in the format of hour : minute : second. Other
neglected parameters keep the current system values.
Sets the month, in the range from 1 to 12.
Sets the day, in the range from 1 to 31.
Sets the year, in the range from 1970 to 2069.
The following example reloads the device.
Ruijie# reload
Reload system?(Y/N) Y
Sending all processes the TERM signal... [ OK ]
Sending all processes the KILL signal... [ OK ]
Restarting system...
To Next Page
Loading...
Need help?
General