Configuration Guide NFPP Commands
The following example displays the configuration.
Ruijie#show nfpp dhcpv6-guard summary
(Format of column Rate-limit and Attack-threshold is
per-src-ip/per-src-mac/per-port.)
Interface Status Rate-limit Attack-threshold
Global Enable -/5/1200 -/10/1500
Maximum count of monitored hosts: 20000
Monitor period: 600s
Enables/Disables the anti-attack function.
In the format of the rate-limit threshold for the source IP
address/ the rate-limit threshold for the source MAC address/
the rate-limit threshold for the port
In the same format as the rate-limit.
dhcpv6-guard attack-threshold
Sets the global attack threshold.
Enables the DHCPv6 anti-attack function.
dhcpv6-guard monitor-period
dhcpv6-guard monitored-host-limit
Sets the maximum number of the monitored
hosts.
Sets the global rate-limit threshold.
Enables the DHCPv6 anti-attack function on
the interface.
Sets the rate-limit threshold and attack
threshold.
To Next Page
Loading...
Need help?
General