Ruijie RG-S29 Series - Page 1332

Command Reference ACL Commands
Parameter
Description
Parameter
Description
interface-name
Redirect interface
id
Access list number
name
Access list name
Defaults
No redirection is configured.
Command
mode
Interface configuration mode
Usage Guide
Use this command to configure access redirection, namely, to redirect the traffic matching the access
list to the specified interface. You can monitor the operation of a specified access list by using this
command.
Configuration
Examples
The following example configures access redirection.
Ruijie(config)# interface gigabitEthernet 0/3
Ruijie(config-if-GigabitEthernet 0/3)# redirect destination interface
gigabitEthernet 0/2 acl1 in
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
1.33 remark
Use this command to write a helpful comment (remark) for an entry in the access list. Use the no form
of this command to remove the remark.
remark text
no remark
Parameter
Description
Parameter
Description
text
Comment that describes the access entry.
Defaults
The access entries have no remarks.
Command
ACL configuration mode.