Ruijie RG-S29 Series

Command Reference DLDP Commands
Parameter
Description
Parameter
Description
resume-num
Recovery count of the peer device link, in the range from 1 to 200.
The parameter indicates the number of DLDP detection packets
received consecutively from the peer device before the link status
goes from DOWN to UP.
Defaults
The default is 3.
Command
Mode
Global configuration mode
Usage Guide
This command is used to set the DLDP recovery count.
Configuration
Examples
The following example sets the DLDP recovery count to 4.
Ruijie#config
Ruijie(config)#dldp resume 4
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
3.6 dldp retry
Use this command to set the DLDP retry count.
Use the no form of this command to restore the default setting.
dldp retry retry-num
no dldp retry
Parameter
Description
Parameter
Description
retry-num
Retry count, in the range from 1 to 3,600
Defaults
The default is 3.
Command
Mode
Global configuration mode
Usage Guide
This command is used to set the DLDP retry count.
Configuration
Examples
The following example sets the DLDP retry count to 4.
Ruijie#config
Ruijie(config)#dldp retry 4