Command Reference VSU Commands
7 VSU Commands
7.1 dad relay enable
Use this command to enable the Dual-Active Detection (DAD) relay function.
Use the no form of this command to restore the default setting.
This function is disabled by default.
Interface configuration mode
This command is only supported on the aggregate port (AP).
The following example enables the AP-based DAD relay function.
Ruijie(config)#interface aggregateport 1
Ruijie(config-if-AggregatePort 1)#dad relay enable
The following example disables the AP-based DAD relay function.
Ruijie(config)#interface aggregateport 1
Ruijie(config-if-AggregatePort 1)#no dad relay enable
Ruijie(config-if-AggregatePort 1)#exit
dual-active pair interface
Configures a pair of Bidirectional Forwarding
Detection (BFD)-based DAD interfaces.
dual-active exclude interface
Configures an exclude interface of DAD.
show switch virtual dual-active
Displays the configuration and status of DAD.
7.2 dual-active bfd interface
Use this command to configure a BFD port.
Use the no form of this command to remove the setting.
To Next Page
Loading...
Need help?
General